Filter
Top Products
57
16. Note wiring and remove all controls from the old tank. Retain the controls and hardware for
reassembly to the new tank. (Review section lll, Removal of Thermostat, High Limit, Combo Valve Burners,
Burner Pilot and Orifice and Ignitor and Pilot Assembly). If you are in doubt of control removal procedures.
17. Install all the old controls onto the new tank.
18. Check that controls are wired properly.
19. Install new tank assembly by reversing steps 1-15.
REMOVAL OF RINSE STATION TANK ASSEMBLY
1. Remove the basket hanger, basket support rack and basket(s) (Fig 92).
Fig. 92
2. Drain the tank and scrap box.
3. From rear of the unit disconnect the main water line and fill hoses.
4. Follow steps 1-7 under Removal of Rinse Station Control Panel.
5. From the front of the appliance with a flat blade screwdriver, loosen the discard hose clamp and disconnect
the discard hose from the tank.