Filter
Top Products
ELECTRIC COMBI OVEN - REMOVAL AND REPLACEMENT OF PARTS
Page 19 of 68
DOOR LAMP
WARNING:
DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1. Remove the screws holding the cover and
gasket.
2. Pull the lamp and socket assembly out from the
door.
3. Hold the lamp assembly and grasp the bulb
using a cloth.
NOTE
: Do not touch the Halogen lamp with bare
hands. If lamp is exposed to oil from the skin, the
life will be reduced. Ensure lamp is free from oil and
dirt before replacing.
4. Pull up on light bulb to remove it from socket.
5. Reverse procedure to install.
OVEN DOOR HINGES
WARNING:
DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1. Remove and disassemble the door as outlined
under “OVEN DOOR”.
2. Remove the light lead wire from the hinge.
NOTE:
Strip 3 inches of the shielding away from the
wires at the terminal end to allow the terminals to be
fed through the hinge one at a time.
3. Remove the cotter pins from the shaft and
remove the shaft from the hinges.
4. Reverse procedure to install.