Filter
Top Products
ELECTRIC COMBI OVEN - REMOVAL AND REPLACEMENT OF PARTS
Page 20 of 68
6 AND 10 LEVELS
DOOR MAGNETIC REED SWITCH
WARNING:
DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1. Remove the right side panel as outlined under
“COVERS AND PANELS”.
2. Remove the nuts that secure the door switch
mounting bracket to the bottom of the control
panel. On 20 levels, the switch is mounted to
the underside of the channel for the door
handle (no bracket required).
3. Disconnect the switch lead wires.
4. Remove the switch from the oven.
5. Reverse procedure to install and check for
proper operation.
DOOR SEAL
1. Turn the oven off.
2. Open the oven door.
3. Remove seal from the edge of the inside glass.
4. Clean the edge of the glass, remove the old
adhesive.
5. Apply red silicone to the replacement seal and
install the seal to the glass edge. The vent
holes must be installed to the outside to allow
the seal to contract when the door is closed.
6. Adjust door closure, if necessary, as outlined
under “OVEN DOOR AND DOOR LOCK
ADJUSTMENT” in “SERVICE PROCEDURES
AND ADJUSTMENTS”.
DOOR LOCKING MECHANISM
WARNING:
DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
Replacement
1. Remove the right side panel as outlined under
“COVERS AND PANELS”.
2. Disconnect the lead wires to the motor and
switches.
3. Remove the nuts from the mounting studs and
remove the assembly from the oven.