Filter
Top Products
The appliance must be installed in accordance with
the regulations in force. All installation and adjust-
ment operations must be carried out by a suitable
qualified person with the relevant national accredi-
tation (i.e. CORGI in UK & Bord Gas in ROI).
The manufacturer declines all liability for any direct
or indirect damage if these regulations are not
complied with.
PRE-INSTALLATION
Prior to installing the product, the protective film
should be removed from the appliance and any
sticky residues removed using soapy warm water.
The appliance should then be checked and any
apparent defects reported to the Waterford Stanley
Service Department (051 302333 For ROI or 028-
87722193 for Northern Ireland)
POSITIONING THE APPLIANCE
This appliance is in class 1 & class 2/1, so there-
fore it can stand alone or be fitted between kitchen
units, provided the following minimum distances
are adhered to:
* 630mm between the top surface of the appli-
ance and horizontal surfaces above it.
* If an extraction hood is installed above the appli-
ance, a minimum distance of 750mm must be
maintained between the top surface of the appli-
ance and bottom surface of the hood.
* 30mm between the side of the appliance and
higher sided units. When installing the appli-
ances between kitchen units, the units must be
able to withstand a temperature of at least
65
o
C and allow ease of removal of the appli-
ance.
ADJUSTING THE COOKER HEIGHT
90cm Models Only
On the 90cm Model, the four adjustable legs are
packed in the oven. On installing the cooker, the
four legs are screwed onto the base plate on each
of the four corners (see Fig.1). The height of the
appliance is then raised by turning the bottom sec-
tion of the leg clockwise, whilst holding the top sec-
tion. The height of the appliance can be adjusted
to a maximum of 920mm.
Fig.1
ALL OTHER MODELS
The four adjustable feet are fixed in the four cor-
ners on the base of the appliance and can be
adjusted by screwing them clockwise or anti-clock-
wise (See Fig. 2). The height of the appliance is
set to the minimum of 890mm during shipping and
can be adjusted to a maximum of 910mm.
PLINTH INSTALLATION
(90cm Models only)
With the legs fitted, the plastic film is removed from
the plinth. The plinth brackets (stored in the oven)
are fixed to the back of the plinth and the plinth is
clipped onto the front adjustable legs.
Fig.2
Fig.3
10
INSTALLATION INSTRUCTIONS (APPLICABLE TO ALL MODELS)