Filter
Top Products
4-6
8. To remove the dual transformer:
a) Disconnect the six pin wire connector
from harness.
b) Remove the two mounting screws from
the transformer bracket.
c) Disconnect the green ground wire from
its terminal.
NOTE: Reconnect the green ground wire when
installing new dual transformer.
Screw (1 of 2)
NOTE: If the switch assembly or light switch
is replaced, the replacement part and decora-
tive overlay must be ordered using the model
number of the ice maker. The service replace-
ment switch is not supplied with a decorative
overlay.
9. To remove the light switch or push-but-
ton switch assembly:
a) Peel off the decorative overlay from the
front of the control housing.
Locking Arm
Light Switch
b) Disconnect the molex plug from switch
assembly. Press the back of switch as-
sembly and push the switch assembly
out of the housing.
Decorative Overlay
Switch Assembly
Dual Transformer
Green Ground Wire
Electrical Shock Hazard
Connect green ground wire to ground
terminal.
Failure to do so can result in death or
electrical shock.
WARNING
WARNING