Whirlpool MH7lOOXY Microwave Oven User Manual


 
Using PAUSE
For best results, some recipes call for stirring, turning over or rearranging food, or for adding ingredients
during cooking. Your microwave oven can be set to pause between COOK I and COOK 2, between
any Cook cycle and PROB TEMP between AUTO SET and a following cycle, between QUICK DEFROST
and a following cycle (except COOK I), or during QUICK DEFROST. This gives you time to stir [casseroles],
turn over [meat] or rearrange [potatoes] food, or to add ingredients. PAUSE is not available between
any cycle and KEEP WARM or after QUICK DEFROST.
DO THIS...
THIS HAPPENS...
1.
Put food in the oven and
close the door.
2. Touch in the desired cooking
instructions for COOK 1,
(see page 17).
E
. . L*
The COOK 1 Indicator Light will be on
and the Display will show “PAUSI’
3.
Touch PAUSE.
4. Touch in the desired cooking
Instructions for COOK 2,
(see page 17).
m
.
5. Touch START.
The Display will show the time you
selected for Cook I.
When Cook 1 is over, 2 beeps will
sound and the oven will shut off. The
Display will show “PAUS:’ and the
COOK 2 Indicator Light will come on.
Open the door. Stir, turn over or rear-
range the food, or add ingredients.
Close the door.
Touch START to continue with Cook 2.
The Display will show the time set for
Cook 2 and begin counting down the
time to show how much cooking time
is left.
NOTE: The oven will remain off until
you touch START.
Using PAUSE with QUICK DEFROST
Your microwave oven can be set to pause halfway through QUICK DEFROST to allow you to stir, turn
over or rearrange the food for more even defrosting.
1. Put frozen food in the oven and close the door.
2. Touch QUICK DEFROST.
3. Touch Number Pads forthe defrosting time you want.
4. Touch PAUSE.
5. Touch START.
When half of the QUICK DEFROST time is remaining, you will hear 2 beeps and the oven will shut off.
6. Open the door. You can stir, turn over or rearrange the food being defrosted, if needed. Close the door.
7. Touch START to continue QUICK DEFROST.
22
NOTE: The oven will remain off until you touch START.