Installation instructions
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND CAREFULLY.
Installing your microwave oven
1. Empty the microwave oven and clean inside
it with a soft, damp cloth. Check for damage such
as misaligned door, damage around the door or
dents inside the oven or on the exterior. If there is
any damage, please do not operate the unit until
it has been checked by an authorized Whirlpool
service technician and any repairs made.
3. Do not block the vent or air intake open-
ings on the rear of the oven. Blocking vent or air
intake openings can cause damage to the
oven and poor cooking results. Make sure the
microwave oven legs are in place to ensure
proper air flow.
I II
11 lr
I
2. Put the oven on a cart, counter, table or shelf
that is strong enough to hold the oven and the
food and utensils you put in it. (The control side
of the unit is the heavy side. Use care when han-
dling.) The weight of the oven is approximately
39 Ibs. (17.7 kg.].
SIDE
2 inches
TOP
1 inch
+
SIDE
1 Inch
+
4. Do not install the microwave oven so
that both sides and the fop are flush with
walls, shelves or cabinets. Leave clear-
ance of at least 2 in. (5.08 cm] on the left
side and 1 in. (2.54 cm) on the top and right
side for proper operation.
Do not install the oven next to or over a
conventional surface unit or in any
area where excessive heat and steam
are generated. This could damage
the microwave oven.