Filter
Top Products
Using your microwave
Microwave oven controls
There are three ports in the control section
-The Digital Display/Clock, and
Indicator Lights
-Command Pads
- Number Pads
These will be covered on the following
pages. Read them carefully.
oven
When you first plug in the oven, a tone sounds
and the Display will be blank. If after you set tl
Clock (page 6) the Display becomes blank
again, it means your electricity was off for
0
while. Reset the Clock
Digital display/clock and indicator
When you are not
using the microwave
oven, this is an accu-
rate digital clock.
When you are using
the microwave oven,
this displays time set-
tings, indicator lights
and shows you what
number pads you
touched.
Command pads
what order. A few
examples:
-CLOCK SET tells
the oven you are
going to set the
clock
- START tells the
oven to start See
page18 for information on the tone you hear
when touching any pad.
Each Command Pad, except START and
CANCEL, lights an Indicator Light. The Indi-
cator Light comes on when you touch the
Command Pad.
While the oven is running, an Indicator Light
[or lights) will be on to show what the oven is
doing.
Number pads