Filter
Top Products
Gas Range Surface Operation 10
Surface Burners
A
spark electrode ignites each surface burner. This control
eliminates the need for continuous open flame pilots. For
added safety and convenience, each burner is designed
with an electronic reignition system. This feature enables
any burner to relight automatically in the event it is acci-
dentally extinguished.
BURNER ASSEMBLY
After removing burner parts for cleaning, it is important
that you reassemble the burners correctly. Refer to the
illustrations below for proper alignment of the base and
upper burner parts. The center burner cap does not have
a special orientation but should be seated flat.
Failure to position the burner parts correctly could
cause flames or gas to escape and burn between
parts, resulting in poor combustion or damage to your
gas range.
IGNITER
CROSS
RING
CENTER
CAP
BURNER BASE
Burner base. Upper burner.
CENTER CAP
OUTER
BURNER RING DRIP PAN
IGNITER
GRATE PLACEMENT
Position the porcelain-coated, cast iron burner grates with
the five fingers of each grate facing toward the front of the
gas range. The back of each grate has three fingers. Refer
to the illustration below.
Grate placement.