Filter
Top Products
97-0019-01-01 37
Configuring the Freedom SW using the SCP
Changing Configurable Settings From
The Device Setup Menu Screen
The Freedom SW can only be configured using the Xanbus SCP.
Follow the procedure in “To view the Freedom SW Setup menu
screen:” on page 30 to bring up the device setup screen for the
Freedom SW inverter/charger.
As discussed in “Reading the Freedom SW Device Setup Screen”
on page 30 the Freedom SW Device Setup menu screen has two
segments. The first segment (lines 2 to 5) displays status
information and appears first in the screen’s initial four lines. The
second segment (lines 6 to 15) contains selectable fields which are
configurable settings.
These configurable settings are:
• Advanced settings
•Inverter
• Search mode
•Charger
• Force charge
• Equalize
• Desired mode
• Clear fault settings
• View device info
• Basic settings
Only nine of these settings are displayed at a time. The Advanced
Settings (Line 6) is not initially listed and only lines 7 through 15
appear. When the Advanced Settings is listed, it will appear on top
of the list for configurable settings and the setup screen will display
lines 6 through 14.
See Table 5, “Configurable Settings” on page 39 for information on
each setting.
Figure 20 Freedom SW Device Setup Menu
FSW3012 00: Setup
Mode
Battery
Load
AC In
Advanced Settings
Inverter
Search Mode
Charger
Force Chg State
Equalize
Desired Mode
Clear Faults Warnings
View Device Info
Basic Settings
Invert
11.8V -88.0A N/A
915W 120V 7A
0V 0A 0Hz
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Standby]
StatusConfigurable Settings
NOTE: The Xanbus SCP only
displays four lines of the
device Setup menu at once.
To view configurable settings,
press the Down arrow button.
* appears only when Enter,
Up, and Down arrow buttons
are pressed together.
Line 1
Line 2
Line 3
Line 4
Line 5
Line 6
Line 7
Line 8
Line 9
Line 10
Line 11
Line 12
Line 13
Line 14
Line 15
Freedom SW 3K2K InvChg Owners Guide.book Page 37 Thursday, July 31, 2014 1:42 PM