Filter
Top Products
97-0019-01-01 13
Freedom SW Inverter/Charger Mechanical Features
Freedom SW Supplied Accessories
NOTE: If any of the supplied accessories are missing, contact
customer service or any authorized dealer for replacement.
Figure 7 Supplied Accessories
1
2
3
4
Item Description
1 Two DC terminal covers are supplied to prevent accidental
contact with the DC cable connectors after installation. The red cover
is for the positive cabling terminal, and the black cover is for the
negative cabling terminal.
2 BTS, the Battery Temperature Sensor consists of:
• Connector plugs into the BTS jack on the Freedom SW.
• Sensor cable is 25 feet (7.6 meters).
• Sensor can be mounted on the side of the battery case or on the
negative battery terminal.
NOTE: The BTS continuously measures the temperature of the battery
and adjusts the charger output for a more accurate, temperature-
compensated charge.
3 Two sets of nuts and washers are used to secure DC cable ends to the
DC terminals.
4 Two Xanbus network terminators are used to properly terminate
each of the two ends of the daisy-chained Xanbus network. For
example, if the Xanbus SCP is connected to the inverter/charger, one
terminator will be plugged to the SCP, one network cable will connect
both devices, and one terminator will be plugged to the inverter/
charger.
IMPORTANT: The Xanbus SCP may perform erratically if the
Xanbus network is not properly terminated.
Freedom SW 3K2K InvChg Owners Guide.book Page 13 Thursday, July 31, 2014 1:42 PM