Xantrex Technology 815-3024 Microwave Oven User Manual


 
72 Freedom SW Owner’s Guide
Troubleshooting
Troubleshooting the Freedom SW via the SCP
The Freedom SW is designed with a number of protection features
to provide efficient operation. If, however, you have any problems
operating your inverter/charger read this troubleshooting chapter.
If you cannot resolve the problem, record the information about
your system. This information will help your dealer or customer
service to assist you better when you contact them.
When a detected fault or warning message appears, you can
acknowledge the message to clear the screen. To acknowledge a
fault or warning message, press the Enter button on the SCP. This
action does not clear the fault or warning condition, so you should
consult “Detected Fault Messages” on page 74 and “Detected
Warning Messages” on page 80 for suggested actions after you have
acknowledged the message. Refer to the Xanbus System Control
Panel Owner’s Guide for more information on detected faults and
warnings.
Detected Fault Types
There are three types of detected fault messages: automatic faults,
manual faults, and escalating automatic faults. Table 1 describes
how they differ in their behavior and how you can respond to them
when they appear on the SCP.
ELECTRICAL SHOCK HAZARD
Do not disassemble the inverter/charger. The Freedom SW
contains no user-serviceable parts.
Failure to follow these instructions will result in death or serious
injury.
Table 1
Detected Fault Types and Behaviors
Fault type Behavior
Automatic fault Clears automatically if the detected condition
that generated the message goes away. You can
also acknowledge automatic faults without
waiting for them to clear automatically.
Manual fault Requires you to clear it by:
Selecting Clear Faults on the Freedom SW
or on the device that generated the detected
fault (if the condition still exists, the fault
message reappears).
Correcting the condition that detected the
fault.
Freedom SW 3K2K InvChg Owners Guide.book Page 72 Thursday, July 31, 2014 1:42 PM