Filter
Top Products
55
USER INSTRUCTIONS
AIRWASH & PRIMARY AIR CONTROLS
1.14 Use a gloved hand to operate air controls.
The opposite end of the door tool can be used to operate
Airwash controls.
PR7518
Single Door
Primary Control
Open
Two Door
Primary Control
Open Close Open
Primary Air Control
Airwash Control
Primary Air Control
PR7519
Airwash Control
Open Close
Airwash Control
SECONDARY AIR CONTROLS
Open
PR7520
Secondary Air Control Secondary Air Control
PR7521
Single & Two Door
Secondary Control
Close
DOOR HANDLE
1.15 To Open and Close the door:
• Drop door tool over knob to fit
• Rotate
1
/2 turn anti-clockwise to open
• Rotate
1
/2 turn clockwise to close
• Lift up door tool to remove
PR7522
PR7523
Open
Open
1 Door 2 Door
DO NOT OPEN THE DOOR WITH BARE HANDS
1.16 To close the door follow the process in reverse.
WARNING
Properly installed, operated and maintained this
appliance will not emit fumes into the room.
Occasional fumes from de-ashing and refuelling may occur.
Persistent fume emission is potentially dangerous and
must not be tolerated.
If fume emission does persist:
• Open doors and windows to ventilate the room
• Leave the room
• Allow fire to burn out or safely dispose of fuel from the
appliance
• Check for chimney blockage and clean if required
• Do not attempt to relight until the cause of the emission
has been identified and corrected
If necessary seek expert advice.
• All open flued appliances can be affected by temporary
atmospheric conditions which may allow fumes to enter
the house. Because of this it is recommended that an
electronic carbon monoxide detector conforming to
BSEN50291 be fitted and maintained.
2. USING THE APPLIANCE FOR THE FIRST
TIME
2.1 To allow the appliance to settle and fixing glues and paint
to fully cure:
• Operate the appliance at a low output for first few days
2.2 Do not touch the paint during the first period of use.
2.3 During this time the appliance may give off some
unpleasant odours:
• Keep the room well ventilated to avoid a build-up of
fumes