6
ZMB 30CST
Ecologically responsible disposal of packaging materials
and old appliances
Packaging materials
ZANUSSI microwave ovens require effective packaging to protect them
during transportation. Only the minimum packaging necessary is used.
Packaging materials (e.g. foil or styrofoam) can place children at risk.
Danger of suffocation. Keep packaging material away from children.
All packaging materials used are environmentally friendly and can be
recycled. The cardboard is made from recycled paper and the wooden
parts are untreated. Plastic items are marked as follows :
«PE» polyethylene eg packaging film
«PS» polystyrene eg packaging (CFC-free)
«PP» polypropylene eg packaging straps
By using and re-using the packaging, raw materials are saved and waste
volume is reduced.
Packaging should be taken to your nearest recycling centre. Contact your
local council for information.
Disposal of old appliances
Old appliances should be made safe before disposal by removing the
plug, and cutting off and disposing of the power cable.
It should then be taken to the nearest recycling centre. Check with your
local Council or Environmental Health Office to see if there are facilities
in your area for recycling the appliance.
i
!
¤
¤
¤
)
¤
¤
¤
)
¤
¤
¤
)
Important information
Installation
Electrical connections
• WARNING! THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety measure not be
observed.
!
This appliance complies with the following EC Directives :
EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC with amendment
90/683/EEC and the CE marking Directive 93/68/EEC.
The oven should be set at least 85 cm above floor level. Make sure that
nothing obstructs the ventilation louvres at the back of the appliance and
that the electrical plug will be accessible after installation. Please refer to
the installation manual included with your oven for further instructions.
Do not use your appliance immediately (wait approx. 1-2 hours) after transfer
from a cold place to a warm place as condensation may cause a malfunction.