Configuring PAD/ATPAD Ports 25
PAD Prompt Table Record
PAD Prompt Table Record
Introduction
You can change the PAD prompt which appears when a terminal connects to a
PathBuilder S200 series switch and is in Command Mode. The default prompt is an
asterisk (*). You use the PAD Prompt Table to change the parameter.
What You See in
This Record
Figure 6 shows how the PAD Prompt Table Record and its configuration parameters
fit into the PathBuilder S200 series switch menu hierarchy.
Figure 6. PAD Prompt Table Record
Before You Begin
Before you can configure parameters, you must log on to the local node’s control
terminal port.
Accessing the PAD
Prompt Table
Record
Follow these steps to access the PAD Prompt Table record:
Entry Number
PAD Prompt Text
Node: Address: Date: Time:
Menu: Configure Path: (Main.6)
Node
Port
Software Key Table
Inbound Call Translation Table
Outbound Call Translation Table
PAD Prompt Table
Step Action Result
1
Select
Configure
from the CTP
Main menu.
The Configure menu appears.
2
Select
PAD Prompt Table
from
the Configure menu.
The PAD Prompt Table and its
parameters appear.
A prompt appears asking you to
configure the next parameter.
3
Enter the parameter values.
4
Press
<ESC>
to return to the
Configure menu after you have
configured all parameters.
