Configuring PAD/ATPAD Ports 49
Remote PAD Parameter Table Record
Remote PAD Parameter Table Record
Introduction
This record contains parameters that define a specified remote PAD. When a call is
made to a port that uses this table entry, an X.29 set command is sent.
What You See In
This Record
Figure 8 shows how the Remote PAD Parameter Table Record and its configuration
parameters fit into the PathBuilder S200 series switch menu hierarchy.
Figure 8. Remote PAD Parameter Table Record
Before You Begin
Before you can configure parameters, you must log on to the local node’s control
terminal port. Refer to the
Configuration Basics Guide
for CTP procedures.
Configuration
Guidelines
When you configure the Remote PAD Parameter Table Record, do not use duplicate
Parameter Numbers.
Accessing the
Remote PAD
Parameter Table
Record
Follow these steps to access the Remote PAD Parameter Table record:
Entry Number
Parameter Number
Parameter Value
Node: Address: Date: Time:
Menu: Configure Path: (Main.6)
Node
Port
•
•
•
Remote Parameter Table
Step Action Result
1
Select
Configure
from the CTP
Main menu.
The Configure menu appears.
2
Select
Remote PAD Parameter
Table
from the Configure menu.
The Remote PAD Parameter Table
and its parameters appear.
A prompt appears asking you to
configure the next parameter.
3
Enter the parameter values.
4
Press
<ESC>
to return to the
Configure menu after you have
configured all parameters.
