Configuring PAD/ATPAD Ports 33
PAD Profile Table Record
#12, PAD Data Restraint
Range: 0, 1
Default: 1
Description: Specifies if and how the XON/XOFF characters sent from the
attached terminal restrain the PAD from sending data:
• 0: No flow control with XON/XOFF
• 1: Allow flow control on outbound data and service signals
For DRO control using V.24 connector control signals (pin 14):
• Set this parameter to 0.
• Use parameter #105, Control Signal (EIA-232-D) Data
Restraint.
• Called Data Restraint Outbound (DRO) when using inband
control.
#13, Line Feed Insertion after CR
Range: 0 to 7
Default: 4
Description: Determines if and how a line feed character is inserted into the
data during Data Mode:
• 0: Line feed is not inserted.
• 1: Line feed is inserted after <CR> in data sent to device.
• 2: Line feed is inserted after <CR> in data from attached
device.
• 4: Line feed is inserted after echo of <CR> to attached device.
• X: Any combination of the above, for example, to combine 1
and 2, enter 3.
