A SERVICE OF

logo

Open as PDF
next previous
47
E
Adjusting the position of the gear change
and rear brake pedals (fig. 35 and fig. 36)
The position of the gearchange and rear brake pedals in
relation to the footrests can be adjusted to suit the
requirements of the rider.
To adjust the position, proceed as follows:
restrain the tie-rod (1) and slacken the locknuts (2) and (3).
Notes
The locknut (2) has a left-hand thread.
Rotate the tie-rod (1) using an open-ended wrench on the
flats to move the gearchange pedal to the required position.
Tighten both nuts against the rod.
2 1 3
fig. 35