A SERVICE OF

logo

Open as PDF
next previous
48
E
To adjust the position of the rear brake lever, proceed as
follows:
Loosen the locknut (4).
Turn the pedal travel adjustment bolt (5) until the pedal is in
the desired position.
When finished, torque locknut (4) to 2.3 Nm.
Operate the pedal by hand to check that there is 1.5 – 2 mm
of freeplay before the brake bites
If not, adjust the length of the master cylinder pushrod as
follows.
Slacken off the locknut (6) on the pushrod.
Tighten the link on the fork (7) to increase play, or unscrew it
to reduce.
Tighten counter nut (6) to 7.5 Nm and check the play again.
7
4
5
6
fig. 36