75
E
Checking and topping up the coolant
(fig. 62)
Check the coolant level in the expansion reservoir on the
right side of the motorcycle. It should be between the two
marks (1) and (2). Mark (2) indicates MAX level, and mark (1)
indicates MIN level.
Top up if below the MIN level.
Remove right-side body panel (page 71).
Unscrew the plug (3, fig. 62) and add a mixture of water
and SHELL Advance Coolant antifreeze or Glycoshell
(35-40% volume) up to MAX mark.
Re-attach the plug (3) and reassemble all removed parts.
This type of mixture gives the best operating conditions
(the coolant starts to freeze at –20 °C/-4 °F).
Cooling circuit capacity: 2.8 dm
3
(litres).
Warning
Place the motorcycle on a flat surface (vertically),
and make sure the engine is cold before proceeding.
MAX
MIN
3
2
1
fig. 62
