CLI commands
<internal addr>
IP address of the device on the internal network that traffic will be routed
to.
<internal-port> The protocol port number that the incoming traffic will be mapped to.
ip rip authentication key-chain
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ip rip authentication key-chain <name>
Specifies a keyed MD5 chain.
no ip rip authentication key-chain
Do not use this Keyed MD5 chain.
ip rip authentication mode
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ip rip authentication mode (md5 | text)
Select RIPv2 authentication mode.
no ip rip authentication mode
Use no RIPv2 authentication.
ip rip authentication string
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ip rip authentication string <secret>
Sets the RIP shared password.
no ip rip authentication string
Clears the RIP shared password.
passive-interface
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
passive-interface
Sets RIP to operate in passive mode (listen for routing broadcasts to update the routing table, but
do not broadcast own routes).
no passive-interface
Sets RIP to operate in active mode (listen for routing broadcasts to update the routing table, and
also broadcast own routes).
router rip
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
router rip
Enable RIP.
no router rip
Disable RIP.
2-82
