CLI commands
active
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
active
Enable this VAP (VSC).
no active
Disable this VAP (VSC).
beacon dtim count
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
beacon dtim count <number>
Defines the DTIM period in the beacon.
Client stations use the DTIM to wake up from low-power mode to receive multicast traffic. The
service controller transmits a beacon every 100 ms. The DTIM counts down with each beacon that
is sent, therefore if the DTIM is set to 5, then client stations in low-power mode will wake up every
500 ms (.5 second) to receive multicast traffic.
beacon transmit power
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
beacon transmit power
Advertise the current transmit power setting in the beacon.
no beacon transmit power
Do not advertise the current transmit power setting in the beacon.
data rate
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
data rate (a | b | g | bg | n) <rate>
Enable the given data rate for a particular PHY type.
no data rate (a | b | g | bg | n) <rate>
Disable the given data rate for a particular PHY type.
public forwarding
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
public forwarding (any | 802.1x | none | ipv6)
Enables support for traffic exchange between wireless client stations.
access lan stations
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
access lan stations
Permits traffic exchange between wireless and LAN stations.
2-97
