Introduction
About this guide
About this guide
This guide explains how to work with the Command Line Interface (CLI) on HP ProCurve
Networking MSM7xx Controllers.
Products covered
This guide covers the following products:
Model Part
MSM710 Access Controller J9328A
MSM710 Mobility Controller J9325A
MSM730 Access Controller J9329A
MSM730 Mobility Controller J9326A
MSM750 Access Controller J9330A
MSM750 Mobility Controller J9327A
MSM760 Access Controller J9420A
MSM760 Mobility Controller J9421A
MSM765 Mobility Controller J9370A
HP ProCurve Product Naming
As of October 1st, 2008, Colubris Networks was acquired by HP ProCurve. HP ProCurve has
begun integrating the Colubris product line into the HP ProCurve Networking product
portfolio (www.procurve.com/news/colubris-10-01-08.htm).
In the online help and this manual, Colubris product names have been changed to their
equivalent HP ProCurve product names.
Note SOAP and SNMP MIBs retain the Colubris naming so you do not need to change your existing
SOAP and MIB usage.
The Colubris Networks product names and their corresponding new HP ProCurve product
names are as follows:
Colubris name HP ProCurve name
MSC-5100 MultiService Controller MSM710 Controller
MSC-5200 MultiService Controller MSM730 Controller
MSC-5500 MultiService Controller MSM750 Controller
MAP-320 MultiService Access Point MSM310 Access Point
1-2
