Revision 1.4.16a Page 103
6.12.4.2.10 Fluid Type
Program this parameter to match the type of fluid whose flow is being monitored.
6.12.4.2.11 Flow Instance
Program this parameter to match the desired instance number of the fluid flow reading for this
channel. You can program this parameter to any value between 0 and 252. The default value for this
parameter i
s 0.
6.12.4.2.12 Flow Label
Program this parameter with a text string which identifies the particular fluid flow parameter being
monitored by this channel. Maretron display
products will display this label text when you are
selecting data to display.
6.12.4.2.13 Volume Instance
Program this parameter to match the desired instance number of the volume reading for this channel.
You can program this parameter to any value between 0 and 252. The default value for this
parameter is 0.
6.12.4.2.14 Volume Label
Program this parameter with a text string which identifies the particular volume parameter being
monitored by this channel. Maretron display products will display this label text when you are
selecting data to display.
6.12.5 Channel #1…
This submenu contains configuration parameters for Channel #1. This menu looks different
depending on whether the FFM100’s operating mode has been set to “Differential” or “Two
Independent Sensors”.
6.12.5.1 Channel #1 (Differential Mode)
This section describes the Channel #1 configuration parameters when the FFM100’s operating mode
has been set to “Differential”.
