A SERVICE OF

logo

Revision 1.4.16a Page 117
®®
6.14.1 Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea. The Advanced Configuration Screen is shown below.
Figure 112 – GPS100 Advanced Configuration Screen
6.14.1.1 Device Instance
The Device Instance will be used to identify the GPS100 device on the network. Unless there are
multiple GPSs on the network, this should be left at zero.
6.14.1.2 GPS Antenna Altitude
The DSM250 is capable of setting the antenna altitude on a Maretron GPS100. You can choose this
setting by pressing the Enter key ( ) with the “Antenna Altitude:” menu item selected which causes
the screen shown in Figure 113 to be displayed.
Figure 113 – Configuring Antenna Altitude on a GPS100