Revision 1.4.16a Page 77
Figure 66 – DSM150 Copy alarms settings from local display
After you select this menu item and press Enter, the alarm settings from this DSM250 unit will be
copied to the selected remote DSM150/DSM250 unit.
6.8.3 Copy device selection from local display
Since it is normally desirable for all DSM150/DSM250 units on a network to display the same
sensors, it is possible to copy the device selection settings from a DSM250 unit to a remotely located
DSM150/DSM250. In this way, it is possible to make all device selection changes on a single
DSM250 unit and then quickly and conveniently duplicate these new device selection settings on
other DSM150/DSM250 units attached to the network. below shows this menu item highlighted.
Figure 67 – DSM250 Copy device selection from local display
After you select this menu item and press Enter, the device selection settings from this DSM250 unit
will be copied to the selected remote DSM150/DSM250 unit.
