Revision 1.4.16a Page 109
You can enable or disable the transmission of a PGN message, or set the frequency of transmission
of the message by pressing the Enter key ( ) on the message to be configured. Options are:
Off – The PGN will not be transmitted
On – The PGN will be transmitted at its default NMEA2000 rate.
0.5s…5s – The PGN will be transmitted at the interval specified.
Select the required option using the Scroll Up and Scroll Down keys followed by the Enter key.
6.13.1.4 Restore Factory Defaults
This option restores all settings on the device to their factory default state.
6.13.2 Channel #0-5
This submenu contains configuration parameters for each of the six channels. These menus look
different depending on whether the channel’s Function has been set to “Tank” or “Pressure/Vacuum”.
6.13.2.1 Channel #0-5 (Tank)
This section describes
the channel configuration menu when the channel ‘s Function has been set to
“Tank” mode. The Channel #0-5 (Tank Mode) menu is too large to fit on a single screen, so it is
shown in two separate screenshots below.
Figure 101 – FPM100 Channel #0 First Configuration Screen (Tank Mode)
