This Chapter contains instructions for initial inspection, preparation for use and repackaging for shi
ment. Connection to PC, setting the communi
cation port and linking Genesys
In order to be operational, the power supply must be connected to an appropriate AC source. The AC
source voltage should be within the power supply specif
ication. Do not apply power before reading
1 below, describes the basic setup procedure. Follow the instructions in Table 3
quence given to prepare the power supply for use.
Initial physical inspection of the power su
Installing the power supply,
Connecting the power suppl
Wire size selection. Local/Remote sensing.
Single or multiple loads.
The power supply setting at shipment.
Prior to shipment this power supply was inspected and found free of mechanical or electrical defects.
Upon unpacking of the power supply, inspect for any damage, which may have occurred in tr
The inspection should confirm that there is no exterior damage to the power supply such as broken
knobs or connectors and that the front panel and meters face are not scratched or cracked. Keep all
packing material until the inspection has been comp
leted. If damage is detected, file a claim with ca
rier immediately and notify the TDK
Lambda Americas Inc. sales or authorized service facility nearest
The GenesysTM power supply series is designed to fit in a standard 19” equipmen
3.4.1 To install the Power Supply in a rack:
mount brackets to install the power supply in the rack.
Use a support bar to provide adequate support for the rear of the power supply. Do not o
struct the air exhaust at the rea
power supplies generate magnetic fields which
might affect the operation of o
ther instruments. If your
equipment is susceptible to magnetic fields, do not position it
cent to the power supply.
