1: Front Panel Controls and Indicators
it, 7 segment LED display. Normally displays the Ou
put Current. When the PREV button is pressed, the display
indicates the programmed setting of Output Cu
Green LED, lights for Constant
High resolution rotary encoder for adjusting the Output Cu
Rate of communication port.
Set desired mode of the Master Power Supply in A
vanced parallel operation.
Output ON/OFF control. Press OUT to set
the output On or Off. Press to reset and turn On the ou
after OVP or FOLD alarm events have occurred.
modes. Press and hold OUT button to tog
Restart”. The VOLT display will c
between “SAF” and “AUT”. Releasing the OUT button while
played, selects that mode.
Green LED, lights when the DC output is enabled.
: Go to local. Press REM/LOC to put the unit
into Local mode (REM/LOC button is disabled at Local
Address and Baud Rate setting. Press
and hold REM/LOC for 3 sec. to set the Address with the
VOLTAGE encoder and the Baud Rate with the CURRENT
Green LED, lights when the unit is in Remote mode.
Foldback protection control.
Press FOLD to set Foldback protection to On.
oldback alarm even, press OUT to e
Press FOLD again to cancel the Foldback protection.
Green LED, lights when Foldback protection is On.
Over Voltage Protection and Unde
Press once to set OVP using VOLTAGE encoder (the cu
rent display shows “OUP”)
Press again to set the UVL using VOLTAGE encoder (the
current display shows “UUL”).
