3D Connexion LST42B Refrigerator User Manual

Open as PDF

of 36

THIS SECTION IS FOR TRACTORS WITH AN

ELECTRIC ATTACHMENT CLUTCH

STEP 14: (SEE FIGURE 14)

•

Attach the two suspension arms to the rear of the

clutch/idler assembly using two 5/16" x 3/4" hex bolts

arms on the outside of the frame with the notches to

the rear.

FIGURE 14

FIGURE 16 VIEW OF BOTTOM

STEP 16: (SEE FIGURE 16)

•

Hook one end of the spring supplied in the parts bag

through the end link of the tensioning chain.

•

With the clutch/idler assembly turned upside down,

hook the other end of the spring onto the end of the

bolt and nut which secure the idler pulley to the upper

idler arm. Assemble a 3/8" hex lock nut (Z) onto the

bolt and nut, leaving enough gap between the nuts for

the spring to pivot freely.

•

Attach a 3/32" hairpin cotter (FF) to the chain, placing

it in the ﬁ fth link from the spring.

CHAIN

(L.H. SIDE)

3/32" HAIR

COTTER PIN (FF)

5TH LINK

LEFT

SIDE

3/8" HEX

LOCK NUT (Z)

SPRING

RIGHT

SIDE

ATTACH

SPRING

HERE

STEP 15: (SEE FIGURE 15)

•

Turn the clutch/idler assembly upside down and place

the extra tensioning chain (JJ) through the left front

hole.

FIGURE 15

TENSIONING CHAIN (JJ)

LEFT FRONT HOLE

STEP 17: (SEE TABLE 1)

•

Two different length drive belts are included with

your snow thrower.

Use the table below to select

the correct drive belt for your type tractor. The part

number is printed on the outside of the belt .

• Set aside the belt that is not for your tractor to avoid

accidentally using it.

SELECT THE CORRECT DRIVE BELT

(Electric clutch tractors with a single front deck

suspension bracket)

55" BELT (PART #46989)