Filter
Top Products
12
STEP 19: (SEE FIGURE 18)
•
Attach the clutch/idler assembly to the tractor frame.
Hook the notched suspension arms onto the two
shoulder bolts (M) assembled to the outside of the
tractor frame. Lift the front of the assembly and attach
it to the R.H. and L.H. hanger brackets using two pivot
lock pins (GG) and 1/8" hairpin cotters (EE).
PIVOT LOCK PIN (GG)
(use second hole)
SHOULDER
BOLT (M)
1/8" HAIRPIN
COTTER (EE)
L.H. HANGER
BRACKET
FIGURE 18 VIEWED FROM LEFT SIDE
STEP 20: (SEE FIGURE 19)
•
Assemble the drive belt onto the engine pulley fi rst
and then onto the large pulley on top of the clutch/
idler assembly. Place the belt to the inside of the idler
pulley and the belt keeper bolt located beside the
large pulley.
•
Place tension on the belt by pulling the left side
tensioning chain (JJ) out as far as the 3/32" hairpin
cotter in the chain will allow. Secure the chain in this
position by inserting a 1/8" hairpin cotter (EE) through
the chain.
IMPORTANT:
Do Not
assemble the drive belt around the
outside of the keeper bolt beside the large pulley.
•
Go to step 48 on page 21.
FIGURE 19 VIEWED FROM UNDERNEATH
1/8" HAIRPIN
COTTER (EE)
ENGINE
PULLEY
ENGINE
PULLEY
KEEPER
BOLT
IDLER
PULLEY
CHAIN (JJ)
(L.H. SIDE)
FIGURE 17
STEP 18: (SEE FIGURE 17)
• Turn the clutch/idler assembly right side up.
•
Slightly loosen the hex bolt next to the fl at idler pulley.
Install the drive belt down between the hex bolt and the
fl at idler pulley with the fl at side of the belt against the
pulley. Retighten the hex bolt.
•
Loop the belt around the large v-pulley, placing it
between the v-pulley and the hex bolt next to the pulley.
STOP
Did you choose the correct drive belt for
your tractor? Using the wrong length belt
may cause premature bearing or belt failure.
CLUTCH/IDLER ASSEMBLY
HEX BOLTS
DRIVE BELT
FLAT IDLER
PULLEY