Filter
Top Products
7
•
Remove all parts and hardware packages from the
carton. Lay out parts and hardware and identify using
the illustrations on pages 4 and 6.
NOTE:
Not all of the supplied parts and hardware will be
needed for your particular tractor. Unneeded items may
be discarded after you have completed assembly and
checked operation of unit.
DO NOT DISCARD
the two
spare shear bolts (N) and 5/16" nylock nuts (Y). Refer to
the Service and Adjustments section on page 27.
REMOVAL OF PARTS FROM CARTON
TOOLS REQUIRED FOR ASSEMBLY
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 9/16" Wrenches
(2) 3/4" Wrenches
(1) Screw Driver
(1) Knife
ADDITIONAL ITEMS REQUIRED
General Purpose Grease
TRACTOR PREPARATION
Before performing these instructions, refer to the Service
and Adjustments section of your tractor owner's manual
for specifi c safety instructions.
•
Allow engine, muffl er and exhaust defl ector to cool
before beginning.
•
Remove any front or rear attachment which is
mounted to your tractor.
•
Remove the mower deck. Refer to your tractor owner's
manual for removal instructions. Mark all loose parts
and save for reassembly.
•
Remove the tractor hood. Refer to your tractor owner's
manual for removal instructions.
CAUTION
:
Before starting
to
assemble the
snow thrower, remove the spark plug wire(s),
set the parking brake and remove the key
from the tractor ignition.
FIGURE 2 RIGHT SIDE VIEW
IMPORTANT:
Right hand (R.H.) and left hand (L.H.) side
of the tractor are determined from the operators position
while seated on the tractor.
REMOVE
FRONT SCREWS
REMOVE
BROWNING SHIELD
MOWER DECK
SUSPENSION
BRACKET
FIGURE 1
INSTRUCTIONS FOR TRACTORS WITH
SINGLE FRONT DECK SUSPENSION
BRACKET
STEP 2: (SEE FIGURE 2)
• Remove the browning shield from the front of the
tractor as shown. Hold onto the shield as you remove
the second screw to prevent it from falling.
•
Be sure to reinstall the browning shield when so
instructed in step 3.
IDENTIFY YOU TRACTOR
STEP 1: (SEE FIGURE 1)
•
Look
under the front of your tractor
Look under the front of your tractorLook
. I
f there is a single
mower deck suspen
sion bracket located
underneath
the mi
dd
le of the front axle, continue
on to step
2
. I
f
yo
ur tractor does not have a mower deck susp
ension
bracket
underneath the mi
dd
le of the front axle
,
skip to
step 21 on page
1
3
for tractors with dual
suspension brackets.
ASSEMBLY