Filter
Top Products
38
2.Secure the drain hose so that it cannot slide off the edge of the sink.
Pass a piece of cord through the hose elbow and fix it to the wall or the
tap.
Anti-flood system
For protection from water damage, the dishwasher is equipped with a
anti-flood system.
In the event of a fault, the safety valve in the water inlet hose immedi-
ately interrupts the supply of water to the appliance and the drain
pump is activated. In this way water can neither escape nor overflow.
The remaining water in the appliance is automatically pumped out.
Electrical Connection
Any electrical work required to install this appliance should be car-
ried out by a qualified electrician or competent person.
1 WARNING - This appliance must be earthed.
The manufacturer declines any responsibility should these safety
measures not be observed.
Before switching on make sure the electricity supply voltage is the
same as that indicated on the appliance rating plate.
To isolate the dishwasher from the mains, remove the mains plug.
Important: The plug must still be accessible after the appliance has
been installed.
Changing a fuse
The appliance is supplied with a 13amp plug fitted. In the event of hav-
ing to change the fuse in the plug supplied, a 13amp ASTA approved
(BS 1363A) fuse must be used.
Should the plug need to be replaced
for any reason, proceed as described
below.
The wires on the mains lead are col-
oured in accordance with the fol-
lowing code.
Green and Yellow: Earth
Blue: Neutral
Brown: Live
Blue
G
reen &
Y
e
ll
ow
Brown
Cord Clamp