Filter
Top Products
S E R V I C E
AR-7E Rotisserie Operation & Care Manual • 22
Part numbers and drawings are subject to change without notice.
To Replace Bulbs:
A Remove four screws holding glass light cover
(CV-26607) and gasket (GS-26609) in place, taking
care to not let the glass cover (GL-26608) fall into
the oven.
B Pull bulb out
C Push replacement bulb (LP-34213) in place
D Re-install glass cover and gasket, securing with four
screws removed in step one.
B UL B R EP L AC E M EN T I NS T RU C TI O NS
A
B & C
D
C A U T I O N
The performance of this unit has been
optimized using the factory provided
bulbs. These bulbs should be
replaced with an exact replacement or
with a factory recommended
replacement. These bulbs have been
treated to resist breakage and must be
replaced with similarly treated bulbs in
order to maintain compliance with NSF
standards. DO NOT over-tighten bulbs
in their receptacles as this can cause
damage to the bulb filament.
C A U T I O N
DO NOT HANDLE NEW BULB WITH
BARE HANDS. WHITE COTTON
GLOVES SHOULD BE WORN WHEN
REPLACING BULBS.
D A N G E R
LO CK- OUT O R PO ST
BR EAKE R PA NEL UNTI L
SE RVIC E WO RK HA S
BE EN CO MPL ETE D.
D A N G E R
DISCONNECT UNIT FROM
POWER SOURCE BEFORE
CLEANING OR SERVICING.
D A N G E R
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
C A U T I O N
THIS SECTION IS PROVIDED FORTHE ASSISTANCE
OF QUALIFIED SERVICETECHNICIANS ONLY AND
IS NOT INTENDED FOR USE BY UNTRAINED OR
UNAUTHORIZED SERVICE PERSONNEL.