Filter
Top Products
INSTALLATION
STEP 4: PREPARE THE WALL AND UPPER CABINET FOR INSTALLATION
[ WARNING ]
To avoid risk of personal injury, electrical shock or death:
• Note where electrical outlets and electrical wires are before you drill into the wall.
• Locate and disconnect power to any electrical circuits that could be affected by installing this oven.
[ & WARNING ]
To avoid risk of personal injury, electrical shock or death, cover the edge of the power supply cord hole with the
power supply cord bushing.
1. Find the points on the mounting plate labeled "A", "B", "C", and "D". Drill a 3/16" diameter hole at any points that are over a
wall stud. Drill a 3/4" diameter hole at any points over drywall.
2. Drill a 3/8" hole at points "J", "K", and "N" on the upper cabinet template.
NOTE: If the bottom of the upper cabinet is recessed 3/4" or more, you will need 2"x2" filler blocks (not included) to provide
additional support for the bolts. See Figure 24.
• Mark the center of each filler block and drill a 3/8" diameter hole at the marks.
• Align filler blocks over the two openings in the top of the microwave oven cabinet and attach to cabinet with masking
tape. See Figure 25.
3. Cut or drill a 2" diameter hole at the area marked "M".
Power supply cord hole on the upper cabinet template. If the
upper cabinet is metal, you will need to cover the edge of the
hole with the power supply cord bushing (supplied) to prevent
damage to the cord from the rough metal edge.
cabinet front filler block cabinet
bottom shelf
4. Cut out the venting areas (with the saber saw):
• Roof-Vented: cut out the shaded area marked "L" on the
upper cabinet template.
• Wall-Vented: go to STEP 5, INSTALL THE MOUNTING
PLATE, located on page 19.
Figure 24
5. Complete whichever venting system you have chosen. Use
caulking compound to seal the exterior wall or roof opening
around the wall cap or roof cap.
Figure 25
17