Filter
Top Products
MAINTENANCE
CARE AND CLEANING
For best performance and safety, keep the oven clean inside
and outside. Take special care to keep the inner door panel
and the oven front frame free of food or grease build-up.
Never use rough powder or pads. Wipe the microwave oven
inside and out, including the hood bottom cover, with a soft
cloth and a warm(not hot) mild detergent solution. Then rinse
and wipe dry. Use a chrome cleaner and polish on chrome,
metal and aluminum surfaces. Wipe spatters immediately with
a wet paper towel, especially after cooking chicken or bacon.
Clean your oven weekly or more often, if needed.
CLEANING THE GREASE FILTERS
The grease filters should be removed and cleaned often, at
least once a month.
1. To remove grease filters, slide each
filter to the side. Pull filters downward
and push to the other side. The filter will drop out.
L LL
"3
2. Soak grease filters in hot water and a mild detergent. Rinse
well and shake to dry. Do not use ammonia or place in a
dishwasher. The aluminum will darken.
3. To reinstall the filters, slide it into the side slot, then push up
and toward oven center to lock.
[ CAUTION ]
To avoid risk of personal injury
or property damage, do not operate oven hood
without filters in place.
CHARCOAL FILTER REPLACEMENT
If your oven is vented inside, the charcoal filter should be
replaced every 6 to 12 months, and more often if
necessary. The charcoal filter cannot be cleaned. To
order a new charcoal filter, contact the Parts Department
at your nearest Authorized Service
Center or call Amana at 1-800-843-0304(inside U.S.A)
1-319-622-5511 (outside U.SA).
Order Charcoal Filter kit # : MVHRK4.
1. Remove the two vent grille mounting screws.
(2 middle screws)
2. Tip the grille forward, then lift it out
3. Open the door.
4. Push the hook and remove old filter.
5. Slide a new charcoal filter into place and close the door.
The filter should rest at the angle shown and set the clock.
41
6. Slide the bottom of the vent cover into place. Push the top
until it snaps into place. Replace the mounting screws. Turn
the power back on at the main power supply and set the clock.