Filter
Top Products
AP24BC250-3, AP24BCF300-3, AP40BC350-3, AP40BCF450-3 Manual
21
y. To change the time, press or then
press
.
00:30 Blinks
The display will show:
PARAM. PROGRAMMING
UV CYCLE
CYCLE TIME
H 00:30 MIN
PARAM. PROGRAMMING
UV CYCLE
PROGRAMMING COMPLETE
DEFROST CYCLE PARAMETERS PROGRAMMING
A
fter about 2 seconds the display will automatically
change to:
The LED for "A" will be "ON".
The LED'S for cycles will be blinking.
z. Press the
button. The LED for "DEFROST"
will be steady "ON".
PARAM. PROGRAMMING
AUTOMATIC MODE
CHOOSE
PROGRAMMING CYCLE
T
he defrost type must be left AIR FLOW.
aa. Press
.
AIR FLOW
Blinks
bb. To change the time, press or then
press
.
05 Blinks
The display will show:
NOTE: The defrost is done by running the evaporator fan for 5 minutes with the door open.
PARAM. PROGRAMMING
DEFROST CYCLE
CHOOSE TYPE
AIR FLOW
PARAM. PROGRAMMING
DEFROST CYCLE
TOTAL TIME
05 MIN
PARAM. PROGRAMMING
DEFROST CYCLE
PROGRAMMING COMPLETE
HEATED PROBE CYCLE PARAMETERS PROGRAMMING
After about 2 seconds the display will automatically
change to:
The LED for "A" will be "ON".
The LED'S for cycles will be blinking.
cc. Press the
button. The LED for "HEATED
PROBE" will be steady "ON".
dd. To change the temperature, press or
then press
.
30 Blinks
PARAM. PROGRAMMING
AUTOMATIC MODE
CHOOSE
PROGRAMMING CYCLE
PARAM. PROGR
A
MMING
HEATED PROBE CYCLE
HEATING TEMPERATURE
30 °F