Filter
Top Products
AP24BC250-3, AP24BCF300-3, AP40BC350-3, AP40BCF450-3 Manual
33
LOADING A ROLL OF PAPER
atterns to pop the front edge up. Lift off
he light will go off.
3. Unroll several inches of paper.
he slot connecting the paper
partment. It can be slid in about 1/4” before it stops.
printer will activate and a rubber roller will pull the paper into the printer
f the
aper spindle into the paper roll and place the roll with the spindle onto the snaps
e up any slack. Make sure the roll of
jam and can possibly damage the
eed Switch, advance the paper about one inch beyond the paper cutter.
nd cut the paper feeding to the printer with
as possible to help the next time you reload the
NG: Pulling the paper out from the back of the printer will damage the
OPERATING THE PRINTER
he P n the printer is a rocker type switch. Push the left side of the rocker switch
go on when the printer switch is ON. Push the
paper.
the ribbon in your printer with an Epson HX-20
frequently, the print impression may become weak because the ribbon
dried out. In that case, advance the ribbon to a new section by holding down the Paper Feed
BON (NO PAPER IN THE PRINTER)
1.
1. Remove the paper cover by pressing on the groove p
the cover.
2. Press the rocker switch to the left. T
4. Cut a straight edge on the paper roll if it is jagged. This will facilitate the entry of the paper into
the printer.
5. Slide the paper (with the roll above the paper) through t
compartment and the printer com
6. While holding the paper in place, press the rocker switch to the Paper Feed position and hold
it there. The
compartment. Release the switch when an inch of paper has emerged from the top o
printer.
7. Slide the paper through the slot in the printer cover.
8. Push the back of the printer cover down and into place.
9. Press the front of the printer cover down to lock in place.
10. Put the p
near the back of the printer. Turn the paper roll to tak
paper turns freely. If it does not turn freely, the paper will
print mechanism.
REMOVING A ROLL OF PAPER
. Using the Paper F1
2. Lift the paper roll away from the printer housing a
scissors. Try to make the cut as square
paper.
3. Pull the remaining paper through the printer mechanism. Be sure to pull the paper from the
top (paper cutter side).
WARNI
print mechanism.
T
to
aper Feed switch o
toggle the printer ON or OFF. A red light will
right side of the switch to advance the
MAINTENANCE
When printing becomes difficult to see, replace
cartridge ribbon.
If your printer is used in
switch for several seconds.
REPLACING THE RIB
Turn the printer OFF.