Filter
Top Products
Rotisserie/Convection Oven Operation
16
Operation with the Controller
Use the procedures below to view a separate recipe or to activate a cook cycle using a one of the
preprogrammed recipes.
Viewing Recipes
1. Turn on the Main Power Switch. The Startup screen will briefly appear then the Controller Off screen will
display.
2. Touch anywhere on the touchscreen. The Recipe Selection screen will appear displaying a list of recipes.
3. Use the up/down arrow buttons to highlight the recipe you wish to view then touch it. A Recipe Settings
screen will appear.
4. Use the up/down arrow buttons to view any settings for the recipe selected.
5. Touch the X button momentarily to return to the previous screen.
Cooking
1. Turn on the Main Power Switch. The Startup screen will briefly appear then the Controller Off screen will
display.
2. Touch anywhere on the touchscreen. The Recipe Selection screen will appear displaying a list of recipes.
3. Use the up/down arrow buttons to highlight the recipe you wish to use then touch the GO button. If a
preheat temperature was programmed then the Preheat/Cook Selection screen will appear. If no preheat
temperature was programmed then the controller enters the Ready To Cook mode displaying the Ready
To Cook screen.
If the Preheat/Cook Selection screen appears, do either of the following:
Touch the Preheat option to enter the Preheat mode. The controller will display the Preheat
screen. Once the preheat temperature is reached the controller enters the Ready To Cook mode.
Touch the Cook option to enter the Ready to Cook mode.
Once the temperature is within 5° of the cook temperature in the Ready To Cook mode the controller will
emit three 2 second beeps indicating that the oven can be loaded with product.
4. Load the product into the oven. Use the Rotor Switch on the front panel to operate the rotors during
loading.
5. Close the door.
6. Touch the COOK button. The controller now enters the cook mode and displays the cooking temperature,
time remaining in the cook cycle and the elapsed time. If necessary, use the EXTRA button to add more
cook time to the cycle. At the end of a cook cycle the controller will emit three 2 second beeps and enter
the Hold mode and display the Hold screen if a Hold temperature was programmed. If a Hold temperature
was not programmed the screen will flash and beep until touched.
7. Open the oven door and check the product for proper internal temperature. If necessary, use the EXTRA
button to add more cook time.
8. Unload the product if it is done.