Filter
Top Products
Rotisserie/Convection Oven Operation
19
Item # Description Function
1 Digital Timer The digital timer consists of an LED, display, beeper and 8 buttons described below:
LED indicator – Prior to the start of a timing cycle the LED will be OFF. When
running a timing cycle the LED will flash. At the end of a timing cycle the LED will
turn ON steady. When idle the LED is off.
TIME SELECT (2 arrow buttons) – Two arrow buttons on the front panel are used to
set the time. Hold the UP ARROW button down to increase the time. The longer the
button is held down, the faster the rate at which the time will increase. The DOWN
ARROW button is used in the same manner as the UP ARROW button except it will
cause the time to decrease. The time is increased or decreased in 30-second
increments.
START/STOP button
Starting the Timer - Pressing this button while the timer is not active will cause the
timer to begin counting down the time on the display.
Stopping the Timer - Pressing this button while the timer is active will stop the
timer from counting down and display the remaining time. Time cannot be changed
with the TIME SELECT buttons at this point. If this button is pressed again the
timer will continue counting down from the point it was stopped.
Resetting the Timer - Pressing and holding this button for longer than two (2)
seconds will reset the timer and the display will return to the original starting time.
At this point, time can be changed using the TIME SELECT buttons or the preset
buttons.
ALARM button - This button allows the user to set an elapsed time at which the
internal alarm will sound during a cycle. The time is set by pressing and holding the
ALARM button while using the UP and DOWN arrows to change the time. The
controller will limit the alarm time to be less than the currently programmed interval
cycle time. The default alarm time is 0:00 which disables it. The ALARM time is
saved on power down in the same manner as the last interval time. When a time
cycle is running and the alarm time has elapsed the internal alarm will sound for 10
seconds. For example, a cycle time 10:00 and alarm time of 2:00 would cause the
alarm to sound for 10 seconds once the controller has counted down from 10:00 to
8:00.
A, B, C, D preset buttons - These buttons are used to save and recall preset cycle
and alarm times, saving operator time and minimizing error when changing interval
cycle times and alarm times. To save the current interval and alarm times into one of
the preset locations, press and hold the A, B, C, or D preset button for 2 seconds
and the controller will double chirp to indicate the times have been saved. To recall
any preset time, press and quickly release the appropriate button and the time
values are loaded and displayed.
Beeper – A beeper sounds when the timer counts down to 0. Pressing the
START/STOP button stops the beeper and resets the timer causing the display to
return to the original starting time. At this point, time can be changed using the TIME
SELECT buttons or the preset buttons. The beeper will also sound for 10 seconds if
the alarm time has elapsed during a timing cycle.
Display – Used to display the time.
2 Thermostat Used to set the cook temperature. Turn the thermostat knob clockwise to the desired
cook temperature. A light will turn on when the thermostat calls for heat. The light will
turn off when the temperature is reached.