Filter
Top Products
Network
Set Password
Sets the Bulldog Service password.
Choose Master/Slave
Please refer to the BULLDOG Service operation mode. If the computer
connects to UPS directly (with RS-232 or USB) and can send commands
to its connected UPS then the BULLDOG Service acts as a "Master". If it
connects to UPS directly (with RS-232 or USB) but only listens to UPS
then it is a "Serial Slave". If the computer is powered by the UPS, but
obtains the UPS information from Master via TCP/IP network then it is a
"Networking Slave". When BULLDOG Service is a Networking Slave you
must assign the Master IP address so that the Networking Slave can
connect to the Master and obtain the UPS information.
a. Master: Configures the BULLDOG Service to be a Master.
b. Serial Slave: Configures the BULLDOG Service to be a Serial Slave.
c. Networking Slave: Configures the BULLDOG Service to be a
Networking Slave.
d. Master IP Address: When BULLDOG Service is a Networking Slave
you must assign the Master IP address so that the Slave can connect
to the Master host and obtain the UPS information.
Belkin Components
30