Filter
Top Products
Wake On LAN
To wake up the remote host, Bulldog Plus sends notification through the
network. You must provide the IP address and the network hardware
address of the remote host. In Windows98, you can execute the
"ipconfig /All" command under the MS-DOS prompt to obtain the network
cards physical address of the local host. Or, input the "arp -a" command
to see the remote host’s physical address. Your network card must
support the remote wakeup feature and this function should be enabled.
a Bulldog Plus Resume The Computer From Suspend Mode: Bulldog
Plus will reinstate the computer into normal mode, and the program will
awaken the remote hosts once the actions have been enabled.
b. Each Time Bulldog Plus Startup: Program will wake up the remote
hosts which are enabled when Bulldog Plus starts and is connected to
the UPS.
Belkin Components
31