Filter
Top Products
Bulldog Plus Installation
Please note that the USB communication is not supported by Windows
95 and NT4.0.
Bulldog Plus Setup:
1. Turn off your computer.
2. Attach the electrical power cable from the computer to the UPS.
3. Attach the electrical power cable from the UPS to an AC power outlet.
4. Plug the communication cable into the UPS, then plug the other end of
the cable into the communication port on your computer.
5. Start your computer.
6. Check the communication type of your UPS. If you select the USB
option you must have connected the UPS to the computer and install the
HID driver.
7. Place the Bulldog CD in your CD-ROM device and execute the
setup.exe to run the setup program.
8. During the installation, the following dialog gives you 3 options:
• Program File: Files contain Bulldog Service, Bulldog Monitor and this
on-line help.
• Audio Files: Some .wav files. These files will be played to notify you
when power event occurs.
• SNMP Files: Bulldog Plus SNMP DLL file.
9. After finishing the installation, the setup process will create a Bulldog
Plus association.
10. The Bulldog Plus software is comprised of two modules:
• An UPS Monitoring Module (Bulldog Service), which runs in the
background as a Windows Service and communicates to the UPS.
• An User Interface Module (Bulldog Monitor), which enables you to
control and configure Bulldog Plus through the drop down menus
and dialog boxes. It also allows you to monitor the UPS through the
Main Screen.
Uninstall: To remove Bulldog Plus from your hard disk.
Help: Bulldog Plus on-line help.
Bulldog Monitor: User interface, used to monitor and configure your UPS.
Bulldog Status: Reflect the status of Bulldog Plus service program, the
service is used to communicate with your UPS.
Belkin Components
6