Filter
Top Products
English 19
Changing to continuous bake setting:
1. Press and hold “TIMER On/Off” down for 5 seconds
until tone is heard, " — — hr" will appear in display for
continuous cooking. The current time of day will return
to the display.
2. To cancel the continuous bake setting, press and hold
for 5 seconds until tone is heard. "12hr" will appear in
display indicating that the control has returned to the
12-Hour Energy Saving feature.
Temperature conversion
The electronic oven control is set to operate in °F
(Fahrenheit) when shipped from the factory. The oven can
be programmed for any temperature from 170°F to 550°F
(77°C to 287°C).
To change the temperature to °C (Celsius) or from °C to
°F (control should not be in a Bake or Clean mode):
1. Press “BROIL” . "— —" appears in the display.
2. Press and hold “+” the until "HI" appears in the display.
3. Press and hold “BROIL” until °F or °C appears in the
display.
4. Press the “+” or “-” to change °F to °C or °C to °F.
5. Press any control pad to return to normal operating
mode.
Setting a silent control panel
When choosing a function, a beep will be heard each time
a pad is pressed. If desired, the control can be
programmed for silent operation. Press and hold “START
TIME”. After 7 seconds, the control will beep once. This will
block the controls from sounding when a pad is pressed. To
return the sound, press and hold “START TIME” again for 7
seconds until the control beeps once.
Setting oven lockout
The control can be programmed to lock the oven door and
lockout the oven control pads.
To set the oven lockout feature:
(for models with Convection)
1. Press “Clear/Off” and “Convection” and hold for 3
seconds. “Loc” will appear in display, the “Door
Locked” indicator light will flash and the motor driven
door lock will begin to close automatically. Allow about
15 seconds for the oven door to lock. Once the oven
door is locked, the current time of day will appear in the
display.
2. To cancel the ovenlockout feature, press “Clear/Off”
and “Convection” and hold for 3 seconds. The control
will unlock the oven door and resume normal
operation.
To set the oven lockout feature:
(for models without Convection feature)
1. Press “Lock” and hold for 3 seconds. “Loc” will appear
in display, the “Door Locked” indicator light will flash and
the motor driven door lock will begin to close automatically.
Allow about 15 seconds for the oven door to lock. Once
the oven door is locked, the current time of day will appear
in the display.
2. To cancel the Oven Lockout feature, press “Lock” and
hold for 3 seconds. The control will unlock the oven door
and resume normal operation.
Note:
• DO NOT open the oven door while the indicator light
is flashing. Allow about 15 seconds for the oven door to
lock. Once the oven door is locked, the current time of
day will appear in the display.
• If any control pad is pressed with the oven lockout
feature active, “Loc” will appear in the display until the
control pad is released.
Setting the minute timer
1. Press “TIMER On/Off”.
2. Press the “+” to increase the time in one minute
increments. Press and hold the “+” to increase the time
in 10 minute increments. The timer can be set for any
amount of time from 1 minute to 11 hours and 59
minutes.
Note: If the “-” pad is pressed first, the timer will
advance to 11 hours and 59 minutes.
3. When the set time has run out, the timer will beep 3
times and will continue to beep 3 times every 60
seconds until “TIMER On/Off” is pressed.
To change the timer while it is in use
While the timer is active and shows in the display, press
and hold the “+” or “-” to increase or decrease the time
remaining.
To cancel the minute timer before the set time has run out
press “TIMER On/Off” once .
Note:
• The indicator light located above the “TIMER On/Off”
pad will glow while the minute timer is active.