Filter
Top Products
9
OPERATING YOUR BREVILLE LIGHT & MIGHTY
BEFORE FIRST USE
Remove and safely discard any packaging
material and promotional labels.
Disassemble the blender jug by following
the steps in the ‘Disassembling the blender’
section below. Wash the lid, inner lid,
blender jug, silicone seal, blender jug base
and blade assembly in warm, soapy water
with a soft cloth. Rinse and dry thoroughly.
Wipe the motor base with a damp cloth and
dry thoroughly.
DISASSEMBLING THE BLENDER
1. Place the motor base on a flat, dry surface
such as a bench top. Ensure that the speed
selection dial is in the OFF position, the
appliance is switched off at the power
outlet and the power cord is unplugged.
2. Remove the blender jug from the motor
base by lifting the jug up by the handle.
3. Remove the lid and inner measuring cup
from the blender jug.
4. Place the jug upside down on a flat, dry
surface such as a bench top.
5. Take the inner measuring cup (which
doubles as a blade assembly removal
tool). Insert the two tabs on the blade
assembly tool into the two grooves on
the blade assembly.
6. Use one hand to hold the jug handle
and the other hand to turn the blade
assembly tool counter clockwise to
loosen the blade assembly.
7. Once loose, lift the blade assembly up
and out of the jug.
8. Remove the silicone seal from outside
the narrow end of the blender jug.