Filter
Top Products
10
11
The Cordless Hand Blender is equipped
with a compact charger plug. It takes up a
minimum of space around the power cord.
When plugged in, the charger plug will
always remain warm, even after the charge
light changes from red to green.
The charging base stores the excess
cord from the charging base. Simply
pull the excessive cord until the desired
length is achieved. The excess cord can
be wrapped inside the cavity under the
charging base.
If you choose to wall mount the charging
base, please follow these steps:
Select a convenient position within 3ft 1.
(1m) of an electrical outlet. If the charging
base is to be mounted closer to an
outlet, wrap any excess cord in the cavity
under the charging base.
Place the wall mount against the wall 2.
in the desired position to mark the drill
holes for the screws (see Fig. 3).
Drill a 0.2 inch (5mm) diameter hole 3.
through the center of each drill hole
mark. Push a plastic wall anchor into
each drilled hole.
Insert a screw into each drilled hole and 4.
turn until the screw heads are 0.1 inch
(3mm) above the wall surface.
Slide the wall mount onto the screws 5.
and attach the charging base to the wall
mount.
The Cordless Hand Blender features
a unique safety switch to ensure the
appliance does not operate accidentally. To
activate the Cordless Hand Blender, follow
the sequence below:
Depress the Power button for 1 second.1.
Continue holding the Power button , 2.
then depress the Speed button
warm to the touch – this is normal. It
is impossible to overcharge the battery
because the Cordless Hand Blender is
designed with overcharge protection
circuitry.
Charging base
The charging base recharges the Cordless
Hand Blender and stores the smoothie
attachment and excess cord from the
charging base (see Fig. 1). The charging
base can be mounted on the wall (see Fig.
2) or placed on a horizontal surface such
as a counter or shelf.
Overload and low voltage protection
The Cordless Hand Blender is fitted with
an automatic cut-out that will operate if the
appliance is overloaded. This is to protect
the motor and battery from excessive heat
build up. The cut-out is only momentary,
and the appliance can then be re-started.
If this automatic cut-out occurs, reduce the
volume of food being mixed and process in
smaller amounts.
The Cordless Hand Blender is fitted with
a second automatic cut-out that operates
when the battery starts to become flat. This
protection is necessary because applying
high loads to flat rechargeable cells
reduces their life. If your appliance cuts out
without being overloaded, return it to the
charging base until sufficiently recharged.
Operating time
The actual operating time of the appliance
will vary significantly with the types and
quantities of food being processed, but is
typically over 10 minutes with a new, fully
charged battery under average conditions.
Battery charging procedures
Plug the charger plug attached to the 1.
charging base into a 110/120 volt
power outlet.
Place the Cordless Hand Blender motor 2.
body into the charging base, making
sure that it firmly sits in the charging base
and the red charging light illuminates.
Your Cordless Hand Blender will begin
charging. When the battery is fully
charged the charging light will change
to green.
To maintain the charge in the motor 3.
body, keep the charging base plugged
into a standard power outlet. When
charging, the charger plug may be
OPERATING YOUR BREVILLE CORDLESS HAND BLENDER OPERATING YOUR BREVILLE CORDLESS HAND BLENDER