Filter
Top Products
15
ASSEMBLY & OPERATION
MOTOR HEAD SAFETY CUT-OFF
The mixer is equipped with a motor head
safety cut-off. If the motor head is lifted at
any time while the mixer motor is switched
on, the safety cut-off will automatically
switch the mixer off.
To restart the mixer turn the speed control
dial to the "Off" position and close the motor
head to the normal position and re-select the
desired speed from the dial.
To turn the mixer off, turn the dial to the
“Off” position, switch the appliance off at
the power outlet and unplug the cord.
ELECTRONIC PROTECTION
CUT-OFF – CURRENT OVERLOAD
The mixer is equipped with an electric
protection cut-off and will automatically
stop operating if the motor is stalled or
overloaded. This is normally a result of
excessive ingredients being processed at
one time. Should the mixer go into this
mode, the LED indicator band will flash and
the error message “E1” will flash on the LCD
screen and the buzzer will “beep” 3 times.
If this error occurs, turn the speed control
dial to the ‘Off” position, switch the
appliance off at the power outlet and unplug
the cord. Remove some of the ingredients in
the mixing bowl and then restart the mixer.
THERMO CUT-OFF –
TEMPERATURE OVERLOAD
The mixer is equipped with a self-resetting
safety device which safeguards against
overheating the motor with excessive
loads. If overheating occurs, the mixer will
automatically activate the overheating
protection device and the motor will switch
itself off. Should the mixer go into this
mode, the LED indicator band will flash and
the error message “E2” will flash on the LCD
screen and the buzzer will “beep” 3 times.
If this error occurs, turn the speed control
dial to the ‘Off’ position, switch the
appliance off at the power outlet and unplug
the cord. Wait at least 15 minutes before
restarting the mixer.
DISASSEMBLING THE MIXER
1. When mixing is complete, turn the
speed control dial to the ‘Off/Stand by’
position, switch the appliance off at the
power outlet and unplug the cord.
2. Remove splash guard if assembled.
Separate pour spout then slide main
ring out of position.
3. Raise the mixer motor head by
depressing the tilt back button and lift
the mixer motor head up until it tilts
back and locks into the open position.