Filter
Top Products
Care and cleaning
13
Ensure the ikon Juice Fountain is turned off by
pressing the ‘On/Off’ button on the control panel to
‘Off’. Then switch the appliance off at the power
outlet and unplug the cord.
Ensure the ikon Juice Fountain is correctly
disassembled. Refer to Disassembling your Breville
ikon Juice Fountain (page 11).
For easier cleaning:
Clean as you go to avoid dried on juice or
pulp residue.
Immediately after each use, rinse removable
parts in hot water to remove wet pulp. Allow
parts to air dry.
To minimize cleaning, line the pulp container with
a plastic freezer bag to collect the pulp. Pulp can
then be used in other dishes (see page 33) or as
compost for the garden or discarded
(see page 17).
Note
Cleaning the motor base
1. Wipe the motor base with a soft, damp cloth
then dry thoroughly.
2. Wipe any excess food particles from the
power cord.
Do not use abrasive scouring pads or cleaners
when cleaning the parts or motor base as they
may scratch the surface.
Note
Cleaning the filter bowl surround, juicer
cover, food pusher, pulp container
1. Wash all parts in warm soapy water with a
soft cloth. Rinse and dry thoroughly.
The filter bowl surround, juicer cover and pulp
container are dishwasher safe (top shelf only).
Note
Cleaning the filter basket
For consistent juicing results always ensure that the
stainless steel filter basket is thoroughly cleaned
using the supplied cleaning brush.
1. Soak the stainless steel filter basket in hot soapy
water for approximately 10 minutes immediately
after juicing is completed. If pulp is left to dry on
the filter it may clog the fine pores of the filter
mesh thereby lessening the effectiveness of
the juicer.
2. Using the cleaning brush, hold the filter basket
under running water and brush from the inside of
the basket to the outer rim. Avoid touching the
small sharp blades in the center of the filter
basket. After cleaning the filter basket, hold it up
towards a light to ensure the fine mesh holes are
not blocked. If the holes are blocked, soak the
filter basket in hot water with 10% lemon juice to
loosen the blocked holes. Alternatively, wash the
filter basket in the dishwasher.
Dissasembling your ikon Juice Fountain
12
THE ST
AINLESS STEEL FILTER BASKET CONTAINS SMALL SHARP BLADES TO CUT AND
PROCESS FR
UITS
AND
VEGET
ABLES,
AVOID TOUCHING BLADES WHEN HANDLING THE
FILTER BASKET.
Step 1
Ensure the ikon Juice Fountain is turned off by
pressing the ‘On/Off’ switch on the control panel
to ‘Off’.
Step 2
Remove the pulp container by tilting the base away
from the motor base, then unlatch it from under the
juicer cover and the container support extending from
under the motor base.
Step 3
Use the grip handle located on the safety locking arm
to lift the locking arm from the juicer cover and lower
down out of position.
Step 4
Lift the juicer cover off the ikon Juice Fountain.
Step 5
Remove the filter bowl surround with the stainless
steel filter basket still in place.
Step 6
To remove the stainless steel filter basket from the
filter bowl surround, insert fingers under the grooves
market ‘LIFT BASKET’ and lift the filter basket up. For
easy cleaning, it is recommended to remove the filter
basket over the sink.