Filter
Top Products
16
OPERATING YOUR BREVILLE DUO-TEMP™ ESPRESSO MACHINE
STEP 3 - TAMPING THE COFFEE
• Distribute the coffee evenly in the Filter
and press down lightly with the tamping
end of the measuring spoon (Refer to
Coffee Making Tips on Page 21).
• Clean any excess coffee from the rim of
the Filter holder to ensure a proper fit
into the Brew Head.
NOTE
The filters are held in place firmly to
ensure that they do not get emptied
into the trash along with coffee.
NOTE
Remove the filter using the indents
in the side of the filter holder, if this
proves difficult the BES800XL comes
with 2 filters. Use the edge of the free
filter as a leverage aid to removing the
filter that is fitted.
STEP 4 - PRIMING THE BREW HEAD
• Before placing the Filter Holder into
position, it is recommended to run a
short flow of water through the Brew
Head.
• Ensure the Selector Control is in the
‘Standby’ position and plug the power
cord into a 110/120V power outlet and
switch on. Press the Power On/Off
button to ‘On’ and the button surround
will illuminate. The Steam button
surround will also illuminate.
• The machine will make a pumping noise
then the Heating Light will illuminate
red. When the correct temperature has
been reached the light will cycle out.
• Place a container under the Brew Head.
• Prime the Brew Head by quickly turning
the Selector Control to the ‘Espresso’
position until water flows then turn back
to the ‘Standby’ position. A pumping
noise will be heard in this operation.
STEP 5 - PRE-WARMING THE CUPS
• The Cup Warming Plate will start to
warm as the machine heats.
• Pre-warm the espresso cups by placing
on the Cup Warming Plate. This will
help maintain the coffee’s optimal
temperature when brewed into the cups.