Filter
Top Products
18
OPERATING YOUR BREVILLE DUO-TEMP™ ESPRESSO MACHINE
STEP 8 – EMPTYING THE
FILTER HOLDER
• Remove the Filter Holder from the Brew
Head by turning the Filter Holder to
the left until it releases. Turn the Filter
Holder upside down to empty the used
coffee (used coffee grounds should be
thrown away and not put down the sink
which may block drains).
• Remove the Filter by using the indents
on the side of the Filter Holder. Rinse
the Filter and Filter Holder with water
and allow to dry.
HOW TO FROTH MILK FOR A
CAPPUCCINO OR LATTÉ
The Die Cast Series Espresso Machine
comes complete with a Commercial Swivel
Steam Wand and Stainless Steel Frothing
Attachment. When using the Frothing
Attachment a large amount of froth is
easily created.
If less froth is required, remove the Frothing
Attachment and steam the milk using
the Steam Wand. To remove the Frothing
Attachment, ensure it is cool then simply pull
down and remove. The Frothing Attachment
can be stored in the Storage Tray inside the
machine if not used regularly.
To refit the Frothing Attachment ensure it
is securely attached to the Steam Wand by
inserting it, from either end opening, onto the
Wand and pushing firmly upwards onto the
rubber surround. Ensure the fine steam holes
on either end of the Frothing Attachment are
clean to achieve optimal frothing.
• The first step in making a cappuccino or
latté is to make a short espresso.
• Then fill the stainless steel frothing jug
L full with cold fresh milk.
• Turn the Selector Control to the ‘Steam’
position and press the ‘Steam’ button.
(Refer to information on Steam and Hot
Water buttons on Page 21.) The ‘Heating’
light will start to flash indicating that the
Thermoblock Heating System is heating
and preparing to create steam.